Installation
Installation is a snap and requires only basic tools. Anyone can safely and securely install the Unleashed product in just three steps!
Step 1: Install the Brackets Find a stud on each side of your garage door. Measure and mark the points to determine bracket placement. Measure from the floor and mark at 19” for the top of the first bracket, 47” for the top of the second, and 75” for the top of the third. Place the bracket at the proper height and mark the location of the bracket holes. Screw your anchors into the wall at the marked locations. Place the bracket in place and secure it to the wall with screws. Repeat for each bracket.
Step 2: Secure the Net Using the snap hook fasteners, secure the net to the brackets using the snap hook fasteners. Once all are attached, tighten the cam straps Ensure the net extends past the edge of the garage door and the weighted bottom is resting on the floor.
Step 3: Install the Ground Strip Ensure the garage floor is clean and dry. Run the adhesive strip along the garage floor where the bottom of the net will rest. Apply pressure to ensure it is secure. Fasten the bottom of the net to the strip. Congratulations, your net is installed.